Related

Wednesday, April 24, 2013

Electricity Safety Tips For Industrial Electricians


Follow these electricity safety tips to keep yourself healthy and safe.
A work site is a dangerous place. With high voltage and huge equipment, an industrial electrician is faced with life-threatening dangers constantly.
Working in high places is a situation which calls for perfect electricity safety practices.
There are many rules and regulations in place to keep you safe, but common sense goes a long way. Many potential hazards can be easily spotted and corrected before a serious accident happens. Keep a few electricity safety tips on the top of your mind at all times and all should go well.
If you spot a defective extension cord, do not use it: replace it immediately. If you see a light fixture that looks like it might fall, stand back and let it fall!
Replacing that fixture is much easier than replacing an eye or a finger, not to mention, if it still has juice flowing to it, you could get a severe shock.

Your Safety is Your Responsibility

Always wear the proper safety clothing and protective gear, like shatter-proof eye protection and non-conductive work boots or other industrial safety footwear.
When working with live circuits, use just one hand and keep yourself insulated at all times.
Housekeeping is a very important daily task for an industrial electrician. Leaving material or tools on a job site can cause tripping hazards for others.
Every industry and firm will have their own set of electricity safety tips, but there are general rules for all industrial electricians to follow.

Plan For Safety

Plan your job carefully and consider all the potential hazards before you start. Always be aware of your surroundings.
Smart ideas include isolating equipment from energy sources, identifying potential electric shock and arc flash points, and establishing clear approach limits to make sure unqualified workers don't wander too close.
Before touching a circuit or conductor, test it for voltage. Never work on electrical equipment or conductors until they have been de-energized, properly locked or tagged out, and all chance of exposure has been eliminated.
When you you work in a live area, even for a short period of time, put on the proper lockouts and tagouts. This also applies when you are working behind equipment where others may not see you and accidentally try to use the equipment with you inside.

Ladder Safety

Ladder Safety is an important part of industrial workplace safety
Whenever a ladder or other elevated equipment is being used, by you or someone else, check and double-check for overhead power sources and obstructions. If the equipment knocks down one of these lines, anyone standing close by can be seriously hurt, maybe even killed.
Verify underground electrical circuits before digging. Know the location of circuit boxes and breakers.


When a circuit breaker gets tripped, find the cause of the trip before you reset it. A circuit breaker is a warning that some serious problems could be hiding somewhere down the line. Usually it is caused by an overload. If you ignore the overload, an electrical fire could break out.
Electricity is a powerful force not to be taken lightly. Follow special electricity safety tips, rules and regulations as they apply to your situation.





No comments:

Post a Comment